MRI-SATA/4P

PCI 2.3 4 port SATA 150 controller

If you need 4 SATA channels added to your PCI system, this is the most cost effective solution for you.

Nowadays you would be hard pushed to find any IDE drives in the market, and if you see no reason to upgrade your whole system otherwise, the MRI-SATA/4P is an ideal way to get SATA support for your machine. Place up to 4 SATA devices onto this card, by maintaining your legacy system configuration.

Stock : 1

Buy Now

This host adapter utilises PCI 2.3 standards, resulting in lower power consumption, whilst reducing your system overheads with its 256-byte FIFOs. Not only is it supported in Vista but it can also host drives above the 137Gb barrier experienced on other systems.

Features

• Hot-plug capability
• 48 bits LBA can Break Capacity-Limit to Support HDD larger than 137GB
• Supports four independent Serial ATA channels
• Supports bootable drive
• Low Profile PCI form factor
• Fully compliant with Serial ATA 1.5Gbps specifications
• Four Pin header on board for LED connection

Specifications

• FCC Class B (DoC) Regulatory approval
• Silicon Image Chipset
• Windows 98SE or later Support
• Compliant with PCI Specification, revision 2.3
• Supports 66 MHz PCI with 32-bit data
• Low Profile PCI form factor bracket available
• RoHS Compliant
• ASPI support
• Supports 64bit / 32bit Windows Vista
• Supports Spread Spectrum in receiver

© MRi (UK) Ltd. 2010 all rights reserved.

Last Updated
9th Apr 2009